美国BSS:BLU-160 16进16出网络音频处理器_周边,处理器,网络音频矩阵尽在香港百利恒国际有限公司

产品类别：数字信号处理器

产品名称：美国BSS:BLU-160 16进16出网络音频处理器

产品价格：面议
关键词：周边,处理器,网络音频矩阵
产品说明：香港百利恒国际有限公司提供美国BSS:BLU-160 16进16出网络音频处理器产品信息,包括美国BSS:BLU-160 16进16出网络音频处理器产品详细介绍,美国BSS:BLU-160 16进16出网络音频处理器产品参数，3D图库等信息，显示的美国BSS:BLU-160 16进16出网络音频处理器图仅为参考,购买请以美国BSS:BLU-160 16进16出网络音频处理器实物为准.

美国BSS:BLU-160 16进16出网络音频处理器技术参数

BSS BLU-160 16进16出网络音频处理器

BLU-16具有灵活的I/O接口和强大的信号处理功能，是一台具有16路输入/输出接口的不带数字音频网络的独立信号处理器，BLU－16是一个在同等配置下性价比更高的解决方案，适用于酒吧，餐馆，体育场馆、剧院，会议中心等场所使用。
　　
基本参数

* 输入/输出： 16路单通道输入/输出，4张模拟接口卡，每张卡含4路输入或输出通道
* 话筒/线形输入：额定增益为0dB，可增加到+48dB，每加一次为+6dB,输入阻抗为3.5KΩ
* DSP数字信号处理器：压缩限幅器、增益调整器、参数均衡器、延时、噪声门、矩阵混音器等
* 频率响应(-10dB)： 20Hz～20kHz，（+0.5/-1dBdB）
* 动态范围： 108dB (22Hz～22kHz 无计权)
* 幻像电源供电： +48V　　
* 连接方式：以太网络为PC连接，RS232接口为第三方连接控制
* 最大连接长度：设备与以太网设备连接长度可达100m/300ft　　
* 控制软件： London Architect
* 尺寸(H(U)×W×D)： 1.75" (1U)×19"×9.0"(45mm×483mm×229mm)
* 重量：9 lbs/4.1 kgs (estimated); 7.3 lbs / 3.3 kgs (estimated)

The Soundweb London BLU-160 offers configurable I/O, configurable signal processing and a high bandwidth, fault tolerant digital audio bus.

The BLU-160 has open architecture which is fully configurable through HiQnet? London Architect. A rich palette of processing and logic objects and a “drag and drop” method of configuration provide a simple and familiar design environment.

This processor features a low latency, fault tolerant digital audio bus of 256 channels which uses standard Category 5e cabling giving a distance of 100m between compatible devices. Fiber media converters can be used to increase the distance between devices to over 40km.

Four card slots which accommodate analog inputs, analog outputs, digital inputs and digital outputs in banks of four facilitate many different device I/O configurations.

Analog Input Cards provide software configurable gain in 6dB steps up to +48dB per channel and software selectable Phantom Power per channel. Digital Input Cards and Digital Output Cards process AES/EBU
and/or S/PDIF audio and offer a variety of clocking and syncing options. (Further information about the I/O cards can be found on dedicated datasheets)

Phantom Power, Sync, Signal Present and Clip information per channel is easily accessible, without the requirement for a PC, from clear front panel LED indication. Device-specific information such as Device Name, Device Type, Firmware Version Number, Time, IP Address and Subnet Mask is available from the front panel display. A bi-directional locate function allows devices to be identified both from and within HiQnet London Architect.

12 Control Inputs and 6 Logic Outputs allow the BLU-160 to be integrated with GPIO compatible devices. The Soundweb London Interface Kit, comprehensive documentation which details how Soundweb London systems can be integrated with third party control systems, is included within the installation of HiQnet London Architect.

The BLU-160 and the other members of the Soundweb London family provide the building blocks of the perfectly tailored system solution.

KEY FEATURES

Four Input / Output Card Slots
Configurable Inputs / Outputs
Analog Inputs (with Phantom Power per Channel)
Analog Outputs
Digital Inputs (AES/EBU and S/PDIF)
Digital Outputs (AES/EBU and S/PDIF)
Configurable Signal Processing
Rich Palette of Processing and Logic Objects
256 Channel, Low Latency, Fault Tolerant Digital Audio Bus
Clear Front Panel LED Indication
Informative Front Panel Display
Bi-Directional Locate Functionality
12 Control Inputs and 6 Logic Outputs for GPIO Integration
Soundweb London Interface Kit for Third Party Control System Integration (Documentation)
HiQnet Device
Configuration, Control and Monitoring from HiQnet London Architect
Front Panel Led Indicators:

Per Input: Signal Present, CLIP, SYNC/48V, I/O card type (IN, OUT, DIG, AEC(BLU-800, 320, 160, 120))

Other: LCD Display, Conductor active, Net Link active, Data Activity, (BLU-800, 320, 80, 32)

Analog Inputs: Up to 16 electronically balanced on Phoenix Combicon removable screw connectors

Mic/Line Inputs: Nominal gain 0dB, electronically switchable up to +48dB,in +6dB steps

Input Impedance: 3.5k?

Maximum Input Level: +20dBu with 0dB input gain,+8dBu with 12dB gain

CMRR: >75dB at 1KHz

Input Noise (E.I.N.): <-128dBu typical with 150? source

Phantom Power: 48V nominal, selectable per input

A/D Latency: 38.7/Fs

Digital Inputs: Up to 16 AES/EBU or S/PDIF on Phoenix/Combicon removable screw connectors

Input Impedance: 110 ohm (AES/EBU), 75 ohm (S/PDIF)

Sample Rate: 48kHz or 96kHz

Sample Rate Conversion: 8kHz-96kHz

THD+N: <-140dB

Latency: 3/Fso + (56.581/Fsi) + (55.658/Fso)

Analog Outputs: Up to 16 electronically balanced on Phoenix/Combicon removable screw connectors

Maximum Output Level: +19dBu

Frequency Response: 20Hz-20KHz (+0.5dB/-1dB)

THD: <0.01% 20Hz to 20KHz, +10dBu output

Dynamic Range: 108dB typical, 22Hz-22KHz unweighted

Crosstalk: <-75dB

D/A Latency: 28/Fs

Digital Outputs: Up to 16 AES/EBU or S/PDIF on Phoenix/Combicon removable screw connectors

Output Impedance: 110 ohm (AES/EBU), 75 ohm (S/PDIF)

Sample Rate: 48kHz or 96kHz

Sample Rate Conversion: 8kHz-96kHz

THD+N: <-140dB

Latency: 3/Fso + (56.581/Fsi) + (55.658/Fso)

Control Ports: 12 inputs and 6 outputs

Control Input Voltage: 0 to 4.5v

Control Input Impedance: 4.7k? to +5V (2-wire mode), >1M? (3-wire mode)

Logic Output Voltage: 0 or +5V unloaded

Logic Output Impedance: 440?s

Logic Output Current: 10mA source, 60mA sink

Watchdog Output: Phoenix/Combicon connector for failsafe control

Opto Output Current: 14mA maximum

Withstanding Voltage: 80V maximum (Off)

Series Impedance: 220? (isolated)

Control Network (All Models):

Connectors: RJ45 Ethernet connector

Maximum Cable Length: 100m/300ft on Category 5e cable between device and Ethernet switch

Digital Audio Bus (BLU-800, BLU-320, BLU-160, BLU-120):

Connectors: 2 x RJ45 Ethernet connectors

Maximum Cable Length: 100m/300ft on Category 5e cable between devices

Maximum Number of Nodes: 32

Latency Per Node: 4(+/-1)Fs

CobraNet? Audio Network (BLU-800, BLU-320, BLU-80, BLU-32 only):

Connectors: 2 x RJ45 connectors

Maximum Cable Length: 100m/300ft on Category 5 cable between device and Ethernet switch

Power and Dimensions (BLU-800, BLU-320, BLU-160, BLU-120), (BLU-80, BLU-32, BLU-16):

Mains Voltage: 100-240V AC, 50/60Hz

Power Consumption: <35VA

BTU Rating: <188 BTU/hr ; <120 BTU/hr

Operating Temperature Range: 5(41) to 35(95) degrees C(degrees F)

Dimensions (H(U) x W x D): 1.75" (1U) x 19" x 12.5" / 9” (45mm x 483mm x 318mm / 228mm )

Weight: 9 lbs/4.1 kgs (estimated); 7.3 lbs / 3.3 kgs (estimated)